Helpr Blog

Common microwave oven problem | Helpr

Common microwave oven problem: Microwave ovens are a testament to man’s ingenuity and creativity. For someone to have the foresight to imagine that food can be cooked without ever being placed in an oven or near a fire is astonishing. The microwave oven is a marvel of science, available right in our kitchens.

So, you’re here because your microwave oven isn’t working as well as it used to or it isn’t working at all. Many times, you can quickly and inexpensively fix the problem by yourself. You will need to have a volt-ohm meter, which you can pick up at most hardware centers. A notebook to record your process is a valuable assistant when it comes to trying to remember which screw goes where. As always, unplug the appliance before troubleshooting unless otherwise noted. Now, let’s see if we can fix that problem

 Your Microwave Oven Won’t Run at All

Unplug the power cord and check for voltage at the outlet. First, inspect the cord for any damage or burn marks. Because of all the safety devices in a microwave oven, any one of them could be the cause, but before you can look more closely, you will need to remove the outside shell of the microwave. Unscrew the screws underneath and on the back that hold the shell in place and slide it off.

Check whether or not the fuse is blown by removing it with a set of fuse pullers. Place it on a paper towel so it doesn’t roll away, and then with your VOM set to RX1, place a probe on each end of the fuse. The reading should be zero. If not, replace the fuse with an identical one.

Your door switch could be the problem. Locate the door switches and remove the leads. With the VOM on RX1, probe the terminals. The reading should be infinity with the door open and zero with it closed. If not, replace it. Make sure to check both door switches.

Also, it could be a bad fan motor. Locate the fan and remove the leads. Once again, with the VOM set to RX1, probe the terminals. If the reading is infinity, then it is bad and needs replacing.

Your Microwave Keeps Blowing Fuses

Check the door switch as described above. The capacitor or diode may be bad. Discharge the capacitor as described earlier in the article, and then test it by removing the leads and setting the VOM to RX100. Probe the terminals. The reading should start in the low ohms and increase toward infinity. Reverse the probes and re-test. The reading should do the same thing, otherwise you’ve found the problem.

To test the diode, disconnect the diode from both the appliance and the capacitor. With the VOM set to RX100 as before, probe the wires. Then reverse the probes and read again. You should get infinity for one reading and low ohms for the other reading. Another cause could be a faulty magnetron, but due to the sensitivity of that piece, it’s best left to a professional.

Your Microwave Oven Cooks Slowly or Unevenly

Check the voltage at the outlet supplying power. If it is lower than 115 volts, there is a problem with your electrical service or breaker. A bad turntable motor may also be the cause. To check it, turn the microwave over onto its top and remove the bottom grill. Set the VOM to RX1, remove one lead from the motor terminals, and probe the terminals. If the reading is infinity, then replace the motor. The magnetron and the wave guide may also be the culprits here, but they need to be serviced by a professional.